I feel like this should be fairly basic, but I can’t figure out how the board is supposed to connect via USB. Attached is a photo of my pogo board, and the pins are incredibly long. I’ve removed the battery and found the 6 corresponding pins on the back of the board, but when I press the pogo against the back, even after the pins retract into the pogo board as far as they’ll go, there’s still a ton of space between the blink and the board. I can get the blink to power on by holding the pogo against the blink with my hand, but it never snaps into place or anything. I’ve tried holding the pogo in place as best I can and pushing code, but the arduino IDE doesn’t recognize that the blink is attached, so clearly i’ve only got a good connection with the power pins. Am I doing something wrong? Is there something wrong with the devkit I’ve been sent? Would love feedback, looking forward to writing some games.
This is as close to connected as I can get it: